69 NE 102 St (14)PERMIT APPLICATION FOR MIAMI SHORES VILLAGE
/Q A) Le, — 3906-0)3-
Date -3 Job Address E� ! I V�i / �� -� Tax Folio � � )637°
Legal Desciiption
Owner's Address
Contracting Co.
Qualifier
Square Ft.
FEES: PERMIT
/ Tenant
Architect/Engineer
Lois c oo $af (LK
S4)n4_
Go Noe- co,
01) tki,
Address 339 g6 69 5 - 01) (C- 331747
SS# Phone( 260 7r7 yr! 3
State # Municipal # Competency # 998Soao. -t Ins. Co. A!J
Bonding Company ', j
Mortgagor UV
Permit Type (circle one): BUILDING
ELLECTRICA MEMECHANICAL CAL ROOFING PAVING FENCE SIGN
WORK DESCRIPTION PEPIP14.. EX.9/ S �" T Afett6L
ogvj ea& APPo /W2 `1
(a
WARNING TO OWNER: YOU MUST RECORD A NOTICE OF COMMENCEMENT AND YOUR FAILURE TO DO SO MAY
RESULT IN YOUR PAYING TWICE FOR IMPROVEMENTS TO YOUR PROPERTY (IF YOU INTEND TO OBTAIN FINANCING,
CONSULT WITH YOUR LENDER OR AN ATTORNEY BEFORE RECORDING YOUR NOTICE OF COMMENCEMENT.)
Application is hereby made to obtain a permit to do work and installation as indicated above, and on the attached addendum (if applicable). I
certify that all work will be performed to meet the standards of all laws regulating construction in this jurisdiction. I understand that separate
permits are required for ELECTRICAL, PLUMBING, SIGNS, POOLS, ROOFING and MECHANICAL WORK.
OWNER'S AFFIDAVIT: I certify that all the foregoing information is accurate and that or 11 be done in compliance with all applicable
laws regulating construction and zoning. Furthermore, I authorize the above -named con ctorito o the work stated.
7
AAnn�,r� °�, ►.�Y{ jviu ti n
ormmonKaCtgiurAl
MV alttIMISSION EX Aft.
��. _ _ -7 f
' of owner and/or Condo Preside Date
D
Notary a to wner and/or Condo President er-Builder
ate -9q
My Conunissio
a6 -0
RADON
Date
Historically Designated: Yes No
Address
Address
Address
Estimated Cost (value)
C.C.F. ` (2 NOTARY
APPROVED: f� �'�y !�
Zoning Building L��� 1 / -'"��! C r
g
Mechanical Plumbing
Master Permit # 445 q b
Phone . �-' 731-/— 6 J'72
Signature o ontractor or Owner- Builder
Electrical
0
Engineering
. i
MIAMI-OADE
PRODUCT CONTROL N JTICE OF ACCEPTANCE
DAB Door Company, Inc.
12195 NW 98th Avenue
Hialeah Gardens FL 33016
on
Page
3.
Acceptance No.:98- 0901.10 (Revises No.: 98- 0409.03)
Expires:08 /14/01
Approved:10221913
-i-
Internet mail address: postmaster@bn' -
Mir
MIAMI COUNTY. FLORIDA
METRO - DADE FLAGt.::R BUILDING
BUILDING COU. CUMI'% (AMA. ufF CE
METRO -DADE FLAGLER BUILDING
140 WEST FLAGLER STREET. SUITE 1603
MIAMI. FLORIDA 33130 -1563
(305) 375-2901 FAX :05)375 -2908
CONTRACTOR LICENSING SECTION
(305) 375 -327 FAX (305) 375-2.558
CONTRACTOR ENFORCEMENT SECTION
(305) 375-2966 FAX (305) 375-2908
PRODUCT CONTROL DIVISION
Your application for Product Approval of: (305) 375 -2902 FAX (3051 372 -6339
Sectional Residential Garage Door
under Chapter 8 of the Metropolitan Dade County Code governing the use of Alternate Materials and
Types of Construction, and completely described in the plans, specifications and calculations as submitted by:
has been recommended for acceptance by the Building Code Compliance office to be used in Dade
County, Florida under the specific conditions set forth on pages 2 et. seq. and the Standard Conditions
This approval shall not be valid afterthe expiration date stated below. The Office of Code Compliance
reserves the right to secure this product or material at anytime from a jobsite or manufacturer's plant for
quality control testing. If this product or material fails to perform in the approved manner, the Code
Compliance Office may revoke, modify, or suspend the use of such product or material immediately. The
applicant shall re- evaluate this product or material should any ammendments to the South Florida Building
Code be enacted affecting this product or material. The Building Code Compliance Office reserves the
the right to revoke this approval, if it is determined by the Building Code Compliance Office that this
product or material fails to meet the requirements of the South Florida Building Code. The expense of
such testing will be incurred by the manufacturer.
Raul Ro• 'guez .
Product Control Supervisor
THIS IS THE COVERSHEET, SEE ADDITIONAL PAGES FOR SPECIFIC AND GENERAL
CONDITIONS
BUILDING CODE COMMITTEE
This application for Product Approval has been reviewed by the Metropolitan Dade County Building
Code Compliance Department and approved by the Building Code Committee to be used in Dade
County, Florida under the conditions set forth above.,
nar es anger,
Director
Building Code Compliance Dept.
Mt trnnoiit:tn Dade County
Hornet: met: ittta :!iwww.nuiidtnecoaronnnr.rnm
r
D a R Dnnr Comnanv. Inc.
NOTICE OF ACCEPTANCE: SPECIFIC CONDITIONS
ACCEPTANCE NO: 9S- 0901.10
. OCT 2 2 19 °F
APPROVED
EXPIRES : 03/14/01
1. SCOPE •
1.1 This revises the Notice of Acceptance No. 93- 0409.03 which was issued on 08/14/98. It approves a Sectional
Steel Door 9 ft wide as described in Section 2 of this Notice of Acceptance. And it is designed to comply with
the South Florida Building Code, 1994 Edition for Miami -Dade Couni• (SFBCC) for the locations where the
pressure requirements, as determined by SFBC Chapter 23, do not exceed the design pressure rating values
indicated in the approved drawings.
2. PRODUCT DESCRIPTION
2.1 The DAB Sectional Door and its components shall be constructed in strict compliance with the following
documents: Drawing No. 98 -01, titled "Sectional Residential Garage Door" prepared by AI- Farooq Corporation.
dated 01/30/93 with latest revision on 08,24/98. Sheet 1 to 2 of 2. It bears the Miami -Dade County Product
Control Approval stamp with the Notice of Acceptance number and approval date by Miami -Dade Product
Control Division. These documents shall hereinafter be referred to as the approved drawings.
3. LIhIITATIONS
3.1 Units with dimensions equal to or smaller than those shown on the approved drawings shall qualify under this
approval.
3.2 This approval requires the manufacturer to do testing of all coils used to fabricate door panels under this Notice
of Acceptance. A minimum of 2 specimens shall be cut from each coil and tensile tested according to ASTM1 E-
3 by a Dade County Approved Laboratory selected and paid by the manufacturer. Every 3 months. 4 times a
year the manufacturer shall mail to this office a copy of the Test Reports with confirmation tha: the specimens
were selected from coils at the manufacturer's production facilities. And a notarized statemen: from the
manufacturer that only coils with a yield strength of 34,000 PSI or more shall be used to make door panels for
Dade County under this Notice of Acceptance.
4. INSTALLATION
4.1 The Sectional Door and its components shall be constructed in strict compliance with the approved drawings.
4.2 The installation of this door does not require a Hurricane Protection System
5. LABELING
5.1 Each door shall bear a permanent label with the manufacturer's name or logo. city, state and the following
statement: "Miami -Dade County Product Control Approved
6. BUILDING PERMIT
6.1 Building Permit shall be accompanied by copies of the following:
6.1.1 This Notice of Acceptance. including two copies of the approved drawings as identified in Section 2.
6.1 .2 Any other document required by the Building Official or the SFBC order to properly evaluate the
installation of this system.
Candido Font, PE. Sr. Product Control Examiner
Product Control Division
T T)r... . /" .. T..
tc 'FPTANrr NO.• 9S- (1901.1(1
. OCT 2 la"
APPROVED
EXPIRES : _08/14/01
NOTICE OF ACCEPTANCE STANDARD CONDITIONS
1. Renewal of this Acceptance (approval) shall be considered after a renewal application has been filed and the original
submitted documentation, including test supporting data, engineering documents, are no older than eight (S) years.
2. Any and all approved products shall be permanently labeled with the manufacturer's name. city. state. and the
following statement: "Miami -Dade County Product Control Approved ", or as specifically stated in the specific
conditions of this Acceptance.
3. Renewals of Acceptance will not be considered if:
a) There has been a change in the South Florida Building Code affecting-the of this product and the product
is not in compliance with the code changes;
b) The product is no lonser the same product (identical) as the one originally approved:
c) If the Acceptance holder has not complied with all the requirements of this acceptance, including the correct
installation of the product;
d) The engineer who originally prepared. signed and sealed the required documentation initially submitted is no longer
practicing the engineering profession.
4. Any revision or change in the materials, use, and/or manufacture of the product or process shall automatically be
cause for termination of this Acceptance, unless prior written approval has been requested (through the filing of a
revision application with appropriate fee) and granted by this office.
5. Any of the following shall also be grounds for removal of this Acceptance:
a) Unsatisfactory performance of this product or process.
b) Misuse of this Acceptance as an endorsement of any product, for sales, advertising or any other purpose.
6. The Notice of Acceptance number preceded by the words Miami -Dade County. Florida. and followed by the
irrtion date may be displayed in advertising literature. If any portion of the Notice of Acceptance is displayed,
then it shall be done in its entirety.
7. A copy of this Acceptance as well as approved drawings and other documents, where it applies. shall be provided to
the user by the manufacturer or its distributors and shall be available for inspection at the job site at all time. The
engineer need not reseal the copies.
8. Failure to comply with any section of this Acceptance shall be cause for termination and removal of Acceptance.
9. This Notice of Acceptance consists of pages 1.2 and this last page 3.
Candido Font. PE. Sr. Product Control Examiner
Product Control Division
END OF THIS ACCEPTANCE
-3-