1160 NE 102 StPERMIT APPLICATION FOR MIAMI SHORES VILLAGE
Date 1 1 119 199 J o b A d d r e s s MOO 1JC (0O S " f " Tax Folio 11— 3 c1O 5 O 1 I O 1 Co O
Legal Description Historically Designated: Yes No ✓
Owner/Lessee / Tenant C h ► S 9-0 SS 0 Master Permit # (-1- .5 8 1 2 )
Owner's Address 1\ lD O U E. 1 O St
Square Ft. .L%
No
APPROVED:
Zoning
Mechanical
as t.C` er
My Commission Expire
FEES: PERMIT
iliaA
Condo President Date
OFFICIAL NOTARY SEAL
SUZANNE H JOSEPH
NOTARY PUBLIC STATE OF FLORIDA
COMMISSION NO. CC731680
MY COMMISSION EXP. APR. 7,2002
RADON
Building
Notary as t
My Commission Exp
C.C.F. r ° NOTARY
Phone 3 5 °7 6$ ° Vo 00 W
Contracting Co. e(A. 12. Co n S r ¢ w 1 01,) Co or S. c1 A Address 147: 51A) 13( b f i a nA i
SS# Phone 3 -6-1 - 14 Z. t
3 1f r 13J1 }cr;k Deets
Ins. Co. VU s - v ay kN,ctoScomp.
Qualifier -e 1 rh ° u - e l 1 .'
State # C t3 003.'3131 Municipal # 3(4 t4 act:. Z Competency #
Architect/Engineer ►1 Address
Bonding Company fl 1a Address
Mortgagor n A Address
Permit Type (circle one): : UILDIN a ELECTRICAL PLUMBING MECHANICAL ROOFING PAVING FENCE SIGN
WORK DESCRIPTION .}I.) C ot. t✓ ate/ S
Estimated Cost (value) 4 5 0 t)
WARNING TO OWNER: YOU MUST RECORD A NOTICE OF COMMENCEMENT AND YOUR FAILURE TO DO SO MAY RESULT IN YOUR
PAYING TWICE FOR IMPROVEMENTS TO YOUR PROPERTY (IF YOU INTEND TO OBTAIN FINANCING, CONSULT WITH YOUR LENDER
OR AN ATTORNEY BEFORE RECORDING YOUR NOTICE OF COMMENCEMENT.)
Application is hereby made to obtain a permit to do work and installation as indicated above, and on the attached addendum (if applicable). I certify that all work
will be performed to meet the standards of all laws regulating construction in this jurisdiction. I understand that separate permits are required for ELECTRICAL
PLUMBING, SIGNS, POOLS, ROOFING and MECHANICAL WORK.
OWNER ` • i' •,/� : I certify that all the foregoing information is accurate and that all • ' will be d ne in co pliance with all applicable laws regulating
cons lion g. Furthermore, I authorize the above -named contractor to do th• w. ed.
■ 1
2
Fer /O . owner and/or Condo President to
es:
Electrical
Signature of Contractor or Owner- Builder
on or Owner- Builder
OFFICIAL NOTARY SEAL
SUZANNE H JOSEPH
NOTARY PUBLIC STATE OF FLORIDA
COMMISSION NO. CC731680
MY COMMISSION EXP. APR. 7,2002
BOND
TOTAL DUE �/2 -
Date
Date
Plumbing Structural Engineer
Florida
Storm
Panels
r
14475 N.W. 26 Avenue • Opa-locka, FL 33054 • (305) 685 -9990 • (305) 685 -9000 • FAX (305) 685 -7511
SHUTTER PRODUCT APPROVAL AUTHORIZATION FORM
Building Official
Dear Mr. Building Official:
We are Dade County Notice of Acceptance holder for the .060 Alwninwn
panels under number 99- 0726.01 (Previous number 96- 0304.1).
This letter authorizes Eagle Construction Companyto use our .060 Aluminum
panels under number 99- 0726.01 to be used at the following job:
1160 NE 102 ST.
Sincerely,
Victor V. Cruz
President
or
Enrique Revilla
Vice - President
1. This form must accompany the application for building permit
and shall become part of the permit documents.
2. The authorized signature must bear the raised corporate seal of
the company holding the Dade County Notice of Acceptance.
I ti
- 7
B4ci t' ouse
'Ron+ 1 ,.
a 3
- 1 - bIqt s . c+ : c).(41
des ►9n ires sure•. 1 S4vey - 50 / a Si°ry - (GO ,
Mob 10Z S�.
MIAMI -DADE
PRODUCT CONTROL NOTICE OF ACCEPTANCE
Florida Storm Panels, Inc.
. 14475 N.W. 26th Avenue
Opa FL 33054
CONTRACTOR ENFORCEMENT SECTION
(305) 375 -2966 FAX (305) 375 -2908
PRODUCT CONTROL. DIVISION
Your application for Product Approval of: (305) 375-2902 FAX (305) 372 -6339
0.060 "Al m Storm Panel Shutter
under Chapter 8 of the Code of Miami -Dade County governing the use of Alternate Materials and Types of
Construction, and completely described herein, has been recommended for acceptance by the Miami -Dade
County Building Code Compliance Office (BCCO) under the conditions specified herein.
This approval shall not be valid after the expiration date stated below. BCCO reserves the right to secure this
product or material at anytime from a jobsite or manufacturer's plant for quality control testing.
If thisproduct or material fails to perform in the approved manner, BCCO may revoke, modify, or suspend
the use of such product or material immediately. BCCO reserves the right to revoke this approval, if it is
determined BCCO that this product or material fails to meet the requirements of the South Florida Building
Code.
The expense of such testing will be incurred by the manufacturer.
Acceptance No.:99- 0726.01
Raul Rodriguez
Chief Product Control Division
TIIIS IS THE COVERSHEET, SEC ADDITIONAL PAGES FOR SPECIFIC AND GENERAL
CONDITIONS
BUILDING CODE & PRODUCT REVIEW COMMITTEE
Expires:08 /26/2002
This application for Product Approval has -been reviewed by the BCCO and approved by the Building Code
and Product Review Committee to be used in Dade County, Florida under the conditions set forth above.
Approved:08 /26/1999
Internet mail address: postmuster@buildingcodeoilline.com
MIAMI -DADE COUNTY, FLORIDA
METRO -DADE FLAGLER BUILDING
BUILDING CODE COMPLIANCE OFFICE
METRO -DADE FLAGLER BUILDING
140 WEST FLAGLER STREET, SUITE 1603
MIAMI. FLORIDA 33130-1563
(305) 375 -2901 FAX (305) 375.2908
CONTRACTOR LICENSING SECTION
(305) 375 -2527 FAX (305) 375 -2558
rancisco Quintana, R.A.
Director
1 of 3 Miami -Dade County
Building Code Compliance Offic
nom:page: http : / /www.huildingcudeouline.cum
•
Florida Storm Panels, Inc. ACCEPTANCE No. : 99- 0726.01
APPROVED AUG 2 6 1999
EXPIRES AUG 2 6 2002
• •
1. SCOPE
NOTICE OF ACCEPTANCE: SPECIFIC CONDITIONS
This approves an aluminum storm panel shutter, as described in Section 2 of this Notice of
Acceptance, designed to comply with the South Florida Building Code, 1994 Edition for Miami -
Dade County, for the locations where the pressure requirements, as determined by SFBC Chapter
23, do not exceed the Design Pressure Rating values indicated in the approved drawings.
2. PRODUCT DESCRIPTION
This aluminum storm panel shutter and its components shall be constructed in strict compliance with
the following documents: Drawing No. 99 -230, titled " 0.060" Aluminum Storm Panel ", prepared
by Knezevich & Associates, Inc., signed and sealed by V. J. Knezevich, P.E., dated July 19, 1999,
last revision #2 dated August 5, 1999, sheets 1 through 4 of 4, bearing the Miami-Dade County
Product Control Approval stamp with the Notice of Acceptance number and approval date by the
Miami -Dade County Product Control Division. These documents shall hereinafter be referred to as
the approved drawings.
3. LIMITATIONS
All permanent set components, included but not limited to embedded anchor bolts, threaded cones,
metal shields, headers and sills, must be protected against corrosion, contamination and damage at
all times.
4. INSTALLATION
This aluminum storm panel shutter and its components shall be installed in strict compliance with
the approved drawings.
5. LABELING
Each panel shall bear a permanent label with the manufacturer's name or logo, city, state and the
following statement: "Miami -Dade County Product Control Approved ".
6. BUILDING PERMIT REQUIREMENTS
6.1 Application for building permit shall be accompanied by copies of the following:
6.1.1 This Notice of Acceptance.
6.1.2 Duplicate copies of the approved drawings, as identified in Section 2 of this Notice of
Acceptance, clearly marked to show the components selected for the proposed
installation.
6.1.3 Any other documents required by the Building Official or the South Florida Building
Code (SFBC) in order to properly evaluate the installation of this system.
■
1 ?b , h 1 • I-Ie A. ar, P.E. - Product Control Examiner
Product Control Division
2 of i
i ►
1
Florida Storm Panels, Inc. ACCEPTANCE No. : 99- 0726.01
APPROVED AUG 2 6 1999
EXPIRES AUG 2 6 2002
NOTICE OF ACCEPTANCE: STANDARD CONDITIONS
•
1 Renewal of this Acceptance (approval) shall be considered after a renewal application has been filed and th
original submitted documents, including test - supporting data, engineering documents, are no older than eigl
(8) years.
2. Any and all approved products shall be permanently labeled with the manufacturers name, city, state, and th(
following statement: "Miami -Dade County Product Control Approved ", or as specifically stated in th(
specific conditions of this Acceptance.
3. Renewals of Acceptapce will not be considered if:
a. There has been a change in the South Florida Building Code affecting the evaluation of this produci
and the product is not in compliance with the code changes.
- b. The product is no longer the same product (identical) as the one originally approved.
c: If the Acceptance holder has not cornplicd with all the requirements of this acceptance, including the
correct installation of the product.
d. The engineer, who originally prepared, signed and sealed the required documentation initially
submitted; is no longer practicing the engineering profession.
4. Any revision or change in the materials, use, and /or manufacture of the product or process shall automatically
be cause for termination of this Acceptance, unless prior written approval.has been requested (through the
filing of a revision application with appropriate fcc) and granted by this office.
5. Any of the following shall also be grounds for removal of this Acceptance:
a. Unsatisfactory performance of this product or process.
b. Misuse of this Acceptance as an endorsement of any product, for sales, advertising or any other
purposes.
6. The Notice of Acceptance number preceded by the words Miami -Dade County, Florida, and followed by the
expiration date may be displayed in advertising literature. If any portion of the Notice of Acceptance is
displayed, then it shall be done in its entirety.
7. A copy of this Acceptance as well as approved drawings and other documents, where it applies, shall be
provided to the user by the manufacturer or its distributors and shall be available for inspection at the job site
at all time. The engineer needs not reseal the copies.
8. Failure to comply with any section of this Acceptance shall be cause for termination and removal of
Acceptance.
9. This Notice of Acceptance consists of pages I, 2 and this last page 3.
END OF TIIIS ACCEPTANCE
4 /1/64—' 1-Ie my A. ak ar, P.E. - Product Control Examiner
Product Control Division
3 of 3