BP-05-1205M I A M I•DADE )♦ ..
BUILDING CODE COMPLIANCE OFFICE (BCCO)
PRODUCT CONTROL DIVISION
NOTICE OF ACCEPTANCE (NOA)
Monier Lifetile, LLC
135 NW 20th Street
Boca Raton, FL 33431
MIAMI-DADE COUNTY, FLORIDA
METRO-DADE FLAGLER BUILDING
140 WEST FLAGLER STREET, SUITE 1603
MIAMI, FLORIDA 33130-1563
(305) 375-2901 FAX (305) 375-2908
SCOPE:
This NOA is being issued under the applicable rules and regulations governing the use of construction materials.
The documentation submitted has been reviewed by Miami -Dade County Product Control Division and accepted
by the Board of Rules and Appeals (BORA) to be used in Miami Dade County and other areas where allowed by
the Authority Having Jurisdiction (AHJ).
This NOA shall not be valid after the expiration date stated below. The Miami -Dade County Product Control
Division (In Miami Dade County) and/or the AHJ (in areas other than Miami Dade County) reserve the right to
have this product or material tested for quality assurance purposes. If this product or material fails to perform in
the accepted manner, the manufacturer will incur the expense of such testing and the AHJ may immediately
revoke, modify, or suspend the use of such product or material within their jurisdiction. BORA reserves the right
to revoke this acceptance, if it is determined by Miami -Dade County Product Control Division that this product or
material fails to meet the requirements of the applicable building code.
This product is approved as described herein, and has been designed to comply with the High Velocity Hurricane
Zone of the Florida Building Code.
DESCRIPTION: Atlantis Shake & Slate Concrete Roof Tile
LABELING: Each unit shall bear a permanent label with the manufacturer's name or logo, city, state and
following statement: "Miami -Dade County Product Control Approved", unless otherwise noted herein.
RENEWAL of this NOA shall be considered after a renewal application has been filed and there has been no
change in the applicable building code negatively affecting the performance of this product.
TERMINATION of this NOA will occur after the expiration date or if there has been a revision or change in the
materials, use, and/or manufacture of the product or process. Misuse of this NOA as an endorsement of any
product, for sales, advertising or any other purposes shall automatically terminate this NOA. Failure to comply
with any section of this NOA shall be cause for termination and removal of NOA.
ADVERTISEMENT: The NOA number preceded by the words Miami -Dade County, Florida, and followed by
the expiration date may be displayed in advertising literature. If any portion of the NOA is displayed, then it shall
be done in its entirety.
INSPECTION: A copy of this entire NOA shall be provided to the user by the manufacturer or its distributors
and shall be available for inspection at the job site at the request of the Building Official.
This NOA consists of pages 1 through 6.
The submitted documentation was reviewed by Frank Zuloaga, RRC
NOA No.: 02-1211.08
Expiration Date: 12/16/07
Approval Date: 01/09/03
Page 1 of 6
Sent Bf: HANSON ROOF TILE;
954 421 2077;
Oct-22-04 2:30PM;
Page 3
ROOFING ASSEMBLY APPROVAL
Category:
Sub Category:
Materials:
I. SCOPE
Roofing
Roofing Tile
Concrete
This renews a roofing :system using Hanson `Barrel' Concrete Roof Tile, as manufactured by
Hanson Roof Tile d.b.a. Pioneer Concrete Tile described in Section 2 of this Notice of
Acceptance. For the locations where the pressure requirements, as determined by applicable
building code do not exceed the values listed in section 4 herein. The attachment calculations
shall be done as a moment based system.
2. PRODUCT DESCRIPTION
Manufactured by
Applicant
1Ianson Barrel Tile
Trim Pieces
Test
Dimensions Specifications
Length: 18"
Width: 9-V2 "
Varying thickness
Length: varies
Width: varies
Varying thickness
TAS 112
TAS 112
Product
Description
High profile, two-piece, extruded concrete roof
tile. For mortar set or adhesive set
applications.
Accessory trim. concrete roof pieces for use at
hips, rakes, ridges and valley terminations.
Manufactured for each tile profile.
2.1Components or products manufactured by others
Product
#30 Felt
#43 Coated Base
Sheet
Mineral Surface
Cap Sheet
Dimensions
NIA
N/A
N/A
Lenzingtex-ZB 140 59" x 164' roll
IJndcrlayment 22Ibs./roll
Test
Specifications
ASTM D 226
Type II
ASTM D 2626
ASTM D 249
Product
Description
Saturated organic felt to
be uscd as a nailed
anchor sheet.
Saturated and coated
organic base sheet for
single or double ply
underlayment.
Mineral surfaced asphalt
roll roofing for use as a
top ply in a double ply
undcrlayment systcm.
TAS 104 Single ply, nail -on
underlaymcnt.
Manufacturer
Generic
(With current NOA)
Generic
(With current NOA)
Generic
(With current NOA)
Lenzing
Performance, Inc.
(With current NOA)
NOA So.: 03-0102.01
Expiration Date: 12/16/07
Approval Date: Ol/03/03
Page 2 of 5
Sent By: HANSON ROOF TILE;
954 421 2077;
Oct-22-04 2:31PM;
Page 4/6
Product
Rainproof II
Ice and Water
Shield
Roof Tile Mortar
("TileTiteTM")
Roof Tile
Adhesive
("Polypro®
Ali 160")
Tile -Bond
Test
Dimensions Specifications
30" x 75' roll
36" x 75' roll TAS 104
or
60" x 75' roll
36" x 75.', roll TAS 103
N/A
N/A
Factory premixed
canisters
3. LIMITATIONS
TAS 123
See NOA
Product
Description
Single ply, nail -on
underlayment with 2"
self -adhering top edge.
Self -adhering
undcrlayment for use as
a top ply in a two-ply
undcrlayment system
with Approved #30 or
#43 as the base layer.
Prepared mortar mix
designed for mortar set
roof tile applications.
Two -component
polyurethane adhesive
designed for adhesive set
roof tile applications.
Single component
See NOA polyurethane foam roof
tile adhesive
Manufacturer
Protect-O-Wrap,
Inc.
(With current NOA)
W.R. Grace Co.
(With current NOA)
Bermuda Roof
Company, Inc.
(With current NOA)
Polyfoam Products,
Inc.
(With current NOA)
Flexible Products
(With current NOA)
3.1 Fire classification is not part of this acceptance.
3.2 For mortar or adhesive set tile applications, a static fold uplift test in accordance with
RAS 106 may be required, refer to applicable building code.
3.3 Applicant shall retain the services of a Miami -Dade County Certified Laboratory to
perform quarterly test in accordance with TAS 112. appendix 'A'. Such testing shall be
submitted to the Building Code Compliance Office for review.
3.4 Minimum undcrlayment shall be in compliance with the applicable Roofing Applications
Standards listed section 4.1. herein.
3.5 30/90 hot mopped undcrlayment applications may be installed perpendicular to the roof
slope unless stated otherwise by the undcrlayment material manufacturers published
literature.
3.6 This acceptance is for wood deck applications. Minimum deck requirements shall be in
compliance with applicable building code.
NOA No.: 03-0102.01
Expiration Date: 12/16/07
Approval Date: 01/03/03
Page 3 of 5
Sent Ei"y: HANSON ROOF TILE;
954 421 2077;
0ct-22-04 2:31PM; Page 5/6
4. INSTALLATION
4.1 , Hanson Barrel Concrete Roof Tile and its components shall be installed in strict compliance
with Rooting Application Standard RAS 120.
4.2 Data For Attachment Calculations
Tile
Profile
Hanson Barrel Tile
Table 1: Aerodynamic Multipliers - X jftl
h(ft)
Direct Deck Application
0.263
Table 2: Restoring Moments due to Gravity - Mg (ft-Ibf)
Tile
Profile
3": 12"
4": 12"
5": 12"
6": 12"
7": 12" or
greater
Hanson Barrel Tile
6.80
6.70
6.56
6.39
6.21
Table 3: Attachment Resistance Expressed as a Moment - Mr (ft-Ibf)
For Single Patty Adhesive Set Systems
Tile
Profile
Tile Application
Minimum Attachment
Resistance
Hanson Barrel Tile
Polyfoam PolyProM
133 (Concrete tiles
Flexible TileBond
84 (Concrete tile)
5 Place 23 grams per pen and 23 grams per cap of PolyPro""'.
6 Place 11.8 grams per pan and 11.6 grams per cap of TileBond.
Table 3A: Attachment Resistance Expressed as a Moment - Mr (ft-Ibf)
For Mortar Set Systems
Tile
Profile -
Tile
Application
Attachment
Resistance
Hanson Barrel Tife
Mortar SetT
24.5
5. LABELING
All tiles shall bear the imprint or identifiable marking of the manufacturer's name or logo, or
following statement: "Miami -Dade County Product Control Approved".
6. BUILDING PERMIT REQUIREMENTS
6.1 Application for building permit shall be accompanied by copies of the following:
6.1.1 This Notice of Acceptance.
6.1.2 Any other documents required by the Building Ofticiul or applicable building
code in order to properly evaluate the installation of this system.
NOA No.: 03-0102.01
Expiration Date: 12/16/07
Approval Date: 01/03/03
Page 4of5
Sent By: HANS* ROOF TILE; 954 421 2077;
Oct-22-04 2:31PM; Page 6/6
PR6 ILE DRAWINGS
1 71 7
/ ,HANSON'aARREL CONCRETE ROOF TILE
BARREL TILE
END OF THIS ACCEPTANCE
NOA No.: 03-0102.01
Expiration Date: 12/26/07
Approval Date: 01/03/03
Page 5 of 5
/5'7'9